the value of $33 (decimal value 51) corresponds to a firm called S&S research (never heard of them before). Should be easier now that I know what MIDI devices you have in your rig. I'll have another look at the list of manufacturer's codes and see if I can find a match. Unfortunately, I'm not sure what that means as there is not a dedicated sync port on the device that is connected to anything and I'm not using MTC. When I run midi monitor it shows the data as coming out of the Sync Port of the MTP AV. I also put a USB hub between the computer and the MTP which some other online boards suggested would help.Īlso, any idea what the little black box with P and A in it on the right side of the window with the Sysex data is? It's interesting and I can't find any reference to it. Tomorrow I will try a hard re-set of the MTP - I did a software reset today thru Clockworks but that did not seem to help. I also re-seated the various cables, pulled a couple of cables that we no longer connected and took a JL Cooper MSB+ that had been hooked up from when I had more synths out of the setup - so cable-wise everything is pretty neat. I think this somehow ties into problem I've been having with notes not playing then all playing at once after a delay, but to be honest, having been using midi literally since it started, this is vexing, to say the least! When i activate the Sysex filter in Logic the extra data is not recorded. I've disconnected the ADAT and MMC points in Clockworks. I tried changing the sync setting in the interface various ways with no luck. The M1R and R8 have active sensing which this may be (although I keep the R8 powered off most of the time - when I try triggering it thru Logic I get an unacceptable delay but that's a different subject). I have a Kurzweil K2000, Korg M1R, Roland D550, Roland R8, Proteus2XR, Proteus2500 and the Wavestation EX.
0 kommentar(er)
